How to install one hole bathroom faucet

In this tutorial, we will review how to replace a bathroom faucet and install a new centerset faucet with a pop-up drain in an existing sink. This helps to solidify the seal, when you go to connect the water, to prevent leaking. Your faucet may or may not have a pop-up drain.

How to Install a Single Handle Bathroom Faucet

Fasten the faucet to the sink by installing the faucet mounting washers and nuts to the underside of the sink. Have a bucket handy to catch any spilling water.

how to install one hole bathroom faucet

Use the flashlight to locate the nuts under the sink if you're having trouble locating them. Repeat for the other handle.

how to install one hole bathroom faucet

When the water is running, check for leaks and drips. Disconnect the supply tubes. If you have a single lever or single ball handle faucet, it is probably a ball-valve faucet, as shown in the photo. Include your email address to get a message when this question is answered. Turn on all the faucets at the sink and keep them running until all the water has drained out.

how to install one hole bathroom faucet

How do I change this? Home Decorating Trends — Homedit.

how to install one hole bathroom faucet

You can also check out this tutorial for removing and installing a kitchen sink faucet. Continue to 2 of 3 below.

How to Remove and Install a Bathroom Faucet

Insert the faucet supply lines through the sink basin holes and press the faucet firmly onto the sink. Loosen the lock nuts to take out the old faucet.

how to install one hole bathroom faucet

Match the tailpipes and valves with the proper holes, and place the faucet into position. To remove old sealant or silicone, dampen a sponge or rag with mineral spirits and wipe the area clean. If the water supply tubes are attached to the tailpieces, feed them through the middle sinkhole and put the faucet into position.

While one person gently pushes the drain pipe upward, the other person will grab the drain ring from in the sink and pull it out. On top of the rubber ring is the faucet itself. Insert the rubber gasket between the base plate and the sink to create a watertight seal. Did this article help you? Before removing any faucet, be sure to turn off the water valves at the supply tubes.